Core switch reset

To reset a core switch, you can use either the command line interface (CLI) or the web-based management interface to restore factory settings or reboot the device.Method 1: Using the Command Line Interface (CLI)Access the CLI: Connect to the switch using a console cable and access the CLI through a terminal emulator (like PuTTY or Tera Term).Enter the Command: To reset the switch to factory defaults, enter the following command:BashCopyboot system config:Factory_Default_Config.cfg This command will load the factory default configuration on the next boot.Reboot the Switch: After entering the command, reboot the switch to apply the changes. You can do this by typing:BashCopyreload Method 2: Using the Web-Based Management InterfaceLog In: Open a web browser and enter the IP address of the switch to access the web interface. Log in with your admin credentials.Navigate to System Settings: Go to System > File and set the Start-Up page to Factory_Default_Config.cfg for the next boot.Reset the Switch: Navigate to System > Reset and select the option to reboot the switch. This will apply the factory default settings .Method 3: Manual ResetDisconnect Ethernet Cables: Before performing a manual reset, disconnect all Ethernet cables from the switch.Press the Reset Button: Locate the reset button on the switch. Using a pin, press and hold the reset button for 15 to 20 seconds until all port LEDs light up.Reconnect and Configure: After releasing the button, reconnect your computer directly to the switch using an Ethernet cable. You may need to reconfigure the switch settings after the reset .Important NotesData Loss: Resetting the switch will erase all current configurations. Ensure you back up any important settings before proceeding.Reconfiguration: After resetting, you will need to reconfigure the switch settings, including IP addresses and VLANs, as it will revert to factory defaults.By following these methods, you can successfully reset your core switch to its factory settings or reboot it as needed.